• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
  • FYI - Your missing Content - your only seeing non-registered Guest Information... Quickly register and sign on to see more! (Shoutbox, current activity etc, more forums)

Pool Skimmer V3.0

KozmoK

Hacker Cracker
Staff member
Admin
Joined
Mar 21, 2011
Likes
2,372
#1
Ok - So I have been a bit busy! I only pick this project up when Its nice and hot outside and I want to use the pool, but hate getting a layer of bugs and leaves out.

Check out my new version of the platform. This consists of 3 parts so far. The top motor mount platform is acrylic or ABS laser cut. The left and right side pontoons so far are going to be MFD 3D Printed.

 

KozmoK

Hacker Cracker
Staff member
Admin
Joined
Mar 21, 2011
Likes
2,372
#3
Did you buy a laser cutter also? man oh man
No There is a place here about 50miles away that cuts them for me. I am sending the pontoons off to be printed by a FDM 3d printer that can handle the large build area tomorrow.